Siemens AC75 - Manual (Page 392)

AC75 AT Command Set
13.20 AT^SCMS
s
AC75_ATC_V01.002 Page 392 of 569 10/30/06
Confidential / Released
13.20 AT^SCMS Send Concatenated Short Messages
Sending a concatenated message is similar to sending a "normal" message, except that each segment of the
concatenated message must be identified by the additional parameters
<seq>
,
<ieia>
and
<ref>
. To send all
segments of the message one by one, the
AT^SCMS
write command must be executed for each segment.
The write command transmits one segment of a concatenated short message from TE to network (SMS-SUB-
MIT).
After invoking the write command wait for the prompt ">" and then start to write the message. To send the mes-
sage simply enter
<CTRL-Z>
. After the prompt a timer will be started to observe the input.
To abort sending use
<ESC>
. Abortion is acknowledged with "OK", though the message will not be sent.
The message reference
<mr>
is returned to the TE on successful message delivery. The value can be used to
identify the message in a delivery status report provided as an unsolicited result code.
Syntax
Notes
• See notes provided for
AT+CMGS
.
• Command is only available if
AT+CMGF
=1.
Test Command
AT^SCMS=?
Response(s)
OK
Write Command
Command syntax for text mode (see
AT+CMGF
=1):
AT^SCMS= <da>
[,
<toda>
],
<seq>
,
<max>
,
<ieia>
,
<ref> <CR>
Text can be entered
<CTRL-Z>
/
<ESC>
Response(s)
+CMGS: <mr>
[,
<scts>
]
OK
If sending fails
ERROR
+CMS ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS + + + + + + + - - -