Siemens AC75 - Manual (Page 41)

AC75 AT Command Set
2.8 ATZ
s
AC75_ATC_V01.002 Page 41 of 569 10/30/06
Confidential / Released
2.8 ATZ Set all current parameters to user defined profile
ATZ
sets all current parameters to the user profile stored with
AT&W
. If a connection is in progress, it will be ter-
minated.
All defined GPRS contexts which are not activated or not online will be undefined if the non volatile storage of
CGDCONT settings is not activated by the
AT^SCFG
parameter "GPRS/PersistentContexts" (see
AT+CGDCONT
).
The user defined profile is stored to the non-volatile memory.
Syntax
Parameter Description
[0] Reset to user profile
Notes
• First the profile will be set to factory default (see
AT&F
). If there is a valid user profile (stored with
AT&W
), this
profile will be loaded afterwards.
• Any additional commands on the same command line may be ignored. A delay of 300 ms is required before
next command is sent, otherwise "OK" response may be corrupted.
Exec Command
ATZ
[
<value>
]
Response(s)
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
V.250 - + + + + + + - + -
<value>
(num)