Siemens AC75 - Manual (Page 182)

AC75 AT Command Set
7.22 AT^SLCC
s
AC75_ATC_V01.002 Page 182 of 569 10/30/06
Confidential / Released
7.22 AT^SLCC Siemens defined command to list current calls of ME
AT^SLCC
covers essentially the same information as GSM 07.07 command
AT+CLCC
, with the following addi-
tions:
• The execute command response contains the additional parameter
<traffic channel assigned>
which
indicates whether the call has been assigned a traffic channel by the network and transmission of DTMF
tones is possible.
• The additional write command allows to activate Event reporting for the list of current calls. If event reporting
is active for an interface, a call status transition (cf.
Call Status Information
) and (if desired) the
assignment of a traffic channel will generate an event report indication to this interface. In order to receive
this event report as an URC, the URC presentation mode for this interface has to be configured with
AT+CMER
.
The frequency of event report generation can be configured with AT command
AT^SCFG
. Refer to
Call
Status Information
for further detail on the configuration options.
• The additional read command allows to determine the event reporting mode
<n>
which indicates whether the
interface receives event report indications for the list of current calls. Mind that the URC will be displayed only
if the URC presentation mode for the interface concerned has been configured with
AT+CMER
.
Syntax
Test Command
AT^SLCC=?
Response(s)
^SLCC:
(list of supported
<n>
s)
OK
Read Command
AT^SLCC?
Response(s)
^SLCC: <n>
OK
Exec Command
AT^SLCC
Response(s)
[^SLCC:
<idx>
,
<dir>
,
<stat>
,
<mode>
,
<mpty>
,
<traffic channel assigned>
[,
<number>
,
<type>
[,
<alpha>
]]]
[^SLCC:
<idx>
,
<dir>
,
<stat>
,
<mode>
,
<mpty>
,
<traffic channel assigned>
[,
<number>
,
<type>
[,
<alpha>
]]]
[^SLCC:...]
OK
ERROR
+CME ERROR
Write Command
AT^SLCC=
[
<n>
]
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
Siemens + + + + + + + - - -