Siemens AC75 - Manual (Page 32)

AC75 AT Command Set
2. Configuration Commands
s
AC75_ATC_V01.002 Page 32 of 569 10/30/06
Confidential / Released
2. Configuration Commands
The AT Commands described in this chapter allow the external application to determine the AC75's behaviour
under various conditions.
2.1 AT&F Set all current parameters to manufacturer defaults
AT&F
sets all current parameters to the manufacturer defined profile. All defined GPRS contexts which are not
activated or not online will be undefined if the non volatile storage of CGDCONT settings is not activated by the
AT^SCFG
parameter "GPRS/PersistentContexts" (see
AT+CGDCONT
).
Syntax
Parameter Description
[0] Set all TA parameters to manufacturer defaults
Notes
• List of parameters reset to manufacturer default can be found in Section 23.6 ,
Factory Default Set-
tings Restorable with AT&F
.
• In addition to the default profile, you can store an individual one with
AT&W
. To alternate between the two pro-
files enter either
ATZ
(loads user profile) or
AT&F
(restores factory profile).
• Every ongoing or incoming call will be terminated.
Exec Command
AT&F
[
<value>
]
Response(s)
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
V.250 - + + + + + + - + -
<value>
(num)