Siemens AC75 - Manual (Page 213)

AC75 AT Command Set
8.10 AT^MONP
s
AC75_ATC_V01.002 Page 213 of 569 10/30/06
Confidential / Released
8.10 AT^MONP Monitor neighbour cells
The
AT^MONP
supplies information of up to six neighbour cells. There are two ways to retrieve the information:
once on request by using the execute command or automatically every
<period>
seconds by using the write
command. To stop the periodic presentation type "AT" or "at".
Syntax
Parameter Description
Display period in seconds
1...254
Notes
• Due to the fact that not all necessary information of the neighbour cells can be decoded during a connection,
there are several constraints to be considered:
- Only neighbour cells that have already been visible in IDLE mode will be further updated, as long as they
are still included in the list.
- Though new neighbour cells can be added to the list (e.g. due to handover), their C1 and C2 parameters
cannot be displayed until the connection is released. In this case "-" is presented for C1 and C2.
- To some extent, the cell monitoring command
AT^SMONC
covers the same parameters. The receiving
level, for example, can be queried with both commands. Yet the resulting values may be slightly different,
even though obtained over a time period of a few seconds. This is quite normal and nothing to worry about,
as the cell information is permanently updated.
• For compatibility with earlier products and to support legacy applications, any input character may be used to
stop the output in certain cases (depending on the settings of
AT+IPR
and
AT+CMUX
).
• If the ME is Java controlled, periodic retrieval of cell information using the write command
AT^MONP
=
<period>
is not supported. If periodic cell information is required simply repeat the execute com-
mands at regular intervals.
Test Command
AT^MONP=?
Response(s)
^MONP:
(list of supported
<period>
s)
OK
Exec Command
AT^MONP
Response(s)
See: Section 8.10.1 , AT^MONP responses
OK
Write Command
AT^MONP= <period>
Response(s)
See: Section 8.10.1 , AT^MONP responses
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS - + + + + + + - - -
<period>
(num)