Siemens AC75 - Manual (Page 516)

AC75 AT Command Set
20.7 AT^SSIO
s
AC75_ATC_V01.002 Page 516 of 569 10/30/06
Confidential / Released
20.7 AT^SSIO Set IO state of a specified pin or port
Syntax
Parameter Description
This can be either an already configured
<pin_id>
or an already opened
<port_id>
.
State to be set for this
<io_id>
.
0 Low for
<pin_id>
1 High for
<pin_id>
0...1023 For
<port_id>
Notes
• If you set a state on a port whose width is less than 10 bits, the bits of
<value>
that are more significant than
the MSB of the port are ignored.
• The write command is only applicable to
<pin_id>
s or
<port_id>
s which are configured as output.
Test Command
AT^SSIO=?
Response(s)
^SSIO:
(list of supported
<io_id>
s), (list of supported
<value>
s)
OK
Write Command
AT^SSIO= <io_id>
,
<value>
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS - + + + + + + - + -
<io_id>
(num)
<value>
(num)