Siemens AC75 - Manual (Page 159)

AC75 AT Command Set
7.3 ATD
s
AC75_ATC_V01.002 Page 159 of 569 10/30/06
Confidential / Released
String of GSM modifiers:
I Activates CLIR (disables presentation of own phone number to called party)
i Deactivates CLIR (enables presentation of own phone number to called party)
G Activate Closed User Group explicit invocation for this call only.
g Deactivate Closed User Group explicit invocation for this call only.
Notes
• The command may be aborted generally when receiving a character during execution. It cannot be aborted
in some connection setup states, such as handshaking.
• Parameter "I" and "i" only if no *#-code is within the dial string.
•
<mgsm>
is not supported for data calls.
•
<n>
is default for last number that can be dialled by
ATDL
.
• See also
ATX
for
<text>
.
• If
ATD
is used with a USSD command (e.g. ATD*100#;) an AT+CUSD=1 is executed implicitly (see
AT+CUSD
).
• Parameter 'G' or 'g' will be ignored if Closed User Group was already activated, respectively deactivated with
AT+CCUG
command before. Call by call invocation of CUG uses the settings provisioned by the provider or,
if available, the settings of the parameters
<index>
and
<info>
made with
AT+CCUG
.
• The ME is equipped with a "Blacklist" function according to GSM02.07 Annex A:
After a predefined number of failed call attempts, the dialed number is entered into a read-only phonebook
called "blacklist" (phonebook "BL"). Call attempts to numbers contained in the blacklist will be barred by ME
and not signalled to the network.
An attempt to start a voice call to a barred phone number will be stopped with a CME ERROR 257 "Call
Barred".
An attempt to start a data or fax call to a barred phone number will be answered immediately with result code
"NO CARRIER".
The barred numbers are automatically removed from the blacklist according to the timing conditions specified
in GSM02.07 Annex A.
• Emergency calls: AC75 supports 112, 911 (standardized GSM emergency numbers, usable with or without
SIM).
If a SIM with ECC-file is inserted, additional call numbers stored in the ECC-file cause an emergency call
setup.
If SIM without ECC-file is inserted, call numbers 000, 08, 110, 112, 911 and 999 cause an emergency call
setup.
If no SIM is inserted, call numbers 000, 08, 110, 112, 118,119, 911 and 999 cause an emergency call setup.
• To start
ATD
via AC75's DTR line
AT^SCFG
may be used, refer parameter
<AutoExecATC>
.
Example
The following example shows the call setup procedure when a call is already active and a second call attempt
fails because the line of the called party is busy:
<mgsm>
(str)
atd03012345678
Dialing out the first party's number.
OK
The first call is established.
ATD03022222222
The number of the second party is dialed.
OK
The response "OK" is issued immediately though no call is established
(same behavior as is you had chosen
AT^SM20
=0.)
BUSY
Line of the second called party is busy.