Siemens AC75 - Manual (Page 509)

AC75 AT Command Set
20.2 AT^SCPIN
s
AC75_ATC_V01.002 Page 509 of 569 10/30/06
Confidential / Released
20.2 AT^SCPIN Pin Configuration
The
AT^SCPIN
write command serves to add (or remove) and configure pins.
Syntax
Parameter Description
0 Close pin
1 Open pin
Pin identifier
0
GPIO1
1 GPIO2
2 GPIO3
3 GPIO4
4 GPIO5
5 GPIO6
6 GPIO7
7 GPIO8
8 GPIO9
9 GPIO10 - The GPIO10 pin can be used either as GPIO or as pulse counter. If
configured as GPIO, the pulse counter option cannot be enabled. Vice versa,
if configured as pulse counter the GPIO option is not available. See
AT^SCCNT
and
AT^SSCNT
for further details on the pulse counter.
Parameter
<direction>
is mandatory when opening a pin, but can be omitted when closing a pin
0 Input
1 Output
Test Command
AT^SCPIN=?
Response(s)
^SCPIN:
(list of supported
<mode>
s), (list of supported
<pin_id>
s), (list of supported
<direction>
s), (list
of supported
<startValue>
s)
OK
Write Command
AT^SCPIN= <mode>
,
<pin_id>
,
<direction>
[,
<startValue>
]
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS - + + + + + + - + -
<mode>
(num)
<pin_id>
(num)
<direction>
(num)