Siemens AC75 - Manual (Page 355)

AC75 AT Command Set
12.4 AT+FRM
s
AC75_ATC_V01.002 Page 355 of 569 10/30/06
Confidential / Released
12.4 AT+FRM Receive Data
The
AT+FRM
command causes the TA to enter the receive mode, using one of the modulation schemes defined
in Section 12.1 , FAX parameters .
An ERROR response code results if the write command is issued while the modem is on-hook. The test com-
mand can be used in on-hook or off-hook mode to check the modulation schemes supported by AC75.
Syntax
Note
•
<mod>
= 3 is not possible.
Test Command
AT+FRM=?
Response(s)
(list of
<mod>
s)
OK
Write Command
AT+FRM= <mod>
Response(s)
CONNECT
If error is related to ME functionality:
ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
TIA/EIA-578 - + - + + - - - - -