Siemens AC75 - Manual (Page 418)

AC75 AT Command Set
15.1 AT^SRSA
s
AC75_ATC_V01.002 Page 418 of 569 10/30/06
Confidential / Released
15.1 AT^SRSA Remote SIM Access Activation
The
AT^SRSA
write command enables and disables RSA connections and allows to control the AC75's SIM
usage scheme.
The
AT^SRSA
read command requests the current RSA status. Every line indicates an RSA connection, if any.
Syntax
Unsolicited Result Code
^SRSA: <devId> , <sapRole> , <connState> , <linkChangeCause>
This URC is generated if either the SIM usage scheme or the SAP connection status has changed due to SAP
message communication or AT command control.
Parameter Description
Activation result
0
No Error
Parameters valid, SAP mode change initiated. However, actual mode change
is signaled via URC "
^SRSA
".
Other values indicate invalid activation requests, no SAP mode change is initi-
ated in the following cases:
1 Error unspecified.
2 Error activation command is busy.
3 Error activation started with serial multiplex mode is off.
4 Error activation started on invalid serial multiplex channel.
5 Error device Id is already known.
6 Error SAP mode is already active.
7 Error invalid parameter.
Test Command
AT^SRSA=?
Response(s)
^SRSA:
(list of supported
<devId>
s) , (list of supported
<sapRole>
s) , (list of supported
<muxChan>
s) , (list
of supported
<dataForm>
s) , (list of supported
<beaconPer>
s) , (list of supported
<discType>
s)
OK
Read Command
AT^SRSA?
Response(s)
[^SRSA:
<devId>
,
<sapRole>
,
<connState>
,
<muxChan>
,
<dataForm>
,
<beaconPer>
]
OK
Write Command
AT^SRSA= <devId>
,
<sapRole>
[,
<muxChan>
[,
<dataForm>
[,
<beaconPer>
[,
<discType>
]]]]
Response(s)
^SRSA: <actResult>
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS - + + + + + + - - -
<actResult>
(num)