Siemens AC75 - Manual (Page 216)

AC75 AT Command Set
8.11 AT^SMONG
s
AC75_ATC_V01.002 Page 216 of 569 10/30/06
Confidential / Released
Notes
• For compatibility with earlier products and to support legacy applications, often any input character will stop
the periodic output of the write command. But since this applies only in certain cases (depending on the set-
tings of
AT+IPR
and
AT+CMUX
), it is recommended to always use "at" or "AT".
• If the ME is Java controlled, periodic retrieval of cell information using the write command
AT^SMONG
=
<table>
,
<period>
is not supported. If periodic cell information is required simply repeat the
execute commands at regular intervals.
8.11.1 AT^SMONG Cell Info Table
Example output for
AT^SMONG
:
Columns of the cell info table:
GPRS Monitor
BCCH G PBCCH PAT MCC MNC NOM TA RAC # Cell #
0637 1 - 4 234 05 2 00 0B
Column Description
BCCH ARFCN of BCCH carrier
G GPRS / EGPRS status:
0 GPRS / EGPRS not available in currently used cell
1 GPRS available in currently used cell
2 GPRS attached
3 EGPRS available in currently used cell
4 EGPRS attached
Note: If the network uses the PBCCH, the correct value can only be displayed if the
AC75 is attached.
PBCCH If PBCCH is present, indication of ARFCN, else ''-'' or if Frequency Hopping is used ''H''
PAT Priority Access Threshold (GSM Rec. 04.08 / 10.5.2.37b)
0 Packet access is not allowed in the cell
1 Spare, shall be interpreted as "000" (packet access not allowed)
2 Spare, shall be interpreted as "000" (packet access not allowed)
3 Packet access is allowed for priority level 1
4 Packet access is allowed for priority level 1 to 2
MCC Mobile Country Code
MNC Mobile Network Code
NOM Network Operation Mode (1...3)
TA Timing Advance Value
RAC Routing Area Code (as hexadecimal value)