Siemens AC75 - Manual (Page 338)

AC75 AT Command Set
11.13 AT+CGSMS
s
AC75_ATC_V01.002 Page 338 of 569 10/30/06
Confidential / Released
11.13 AT+CGSMS Select service for MO SMS messages
Syntax
Command Description
The test command is used for requesting information on which services and service preferences can be set by
using the
AT+CGSMS
write command
The read command returns the currently selected service or service preference.
The write command is used to specify the service or service preference that the MT will use to send MO SMS
messages. If parameter
<service>
is not given, the current value remains unchanged.
Parameter Description
A numeric parameter which indicates the service or service preference to be used. Parameter is global for all
interfaces and volatile.
0
GPRS
1 Circuit switched
2 GPRS preferred (use circuit switched SMS transfer if GPRS SMS transfer is
not possible, for example when the mobile is not GPRS attached or the network
does not support SMS over GPRS)
3 (&F)(P) Circuit switched preferred (use GPRS if circuit switched is not available)
Note
• Sending SMS via GPRS is only possible when mobile is attached using
AT+CGATT
.
Test Command
AT+CGSMS=?
Response(s)
+CGSMS:
(list of supported
<service>
s)
OK
Read Command
AT+CGSMS?
Response(s)
+CGSMS: <service>
OK
Write Command
AT+CGSMS=
[
<service>
]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 + + + + + + + - + -
<service>
(num)