Siemens AC75 - Manual (Page 210)

AC75 AT Command Set
8.9 AT^MONI
s
AC75_ATC_V01.002 Page 210 of 569 10/30/06
Confidential / Released
8.9 AT^MONI Monitor idle mode and dedicated mode
The
AT^MONI
command supplies information of the serving/dedicated cell. There are two ways to retrieve the
information: once on request by using the execute command or automatically every
<period>
seconds by using
the write command. To stop the periodic presentation type "AT" or "at".
Syntax
Parameter Description
Display period in seconds
1...254
Notes
• The two header lines (see Section 8.9.1 , AT^MONI responses ) are output after every ten data lines.
• The length of following output lines exceeds 80 characters. Therefore a terminal program may draw a carriage
return on a screen. However, this is not part of the response.
• If the ME is Java controlled, periodic retrieval of cell information using the write command
AT^MONI
=
<period>
is not supported. If periodic cell information is required simply repeat the execute com-
mands at regular intervals.
• The parameters LAC and cell are presented as hexadecimal digits, the remaining parameters are composed
of decimal digits.
Test Command
AT^MONI=?
Response(s)
^MONI:
(list of supported
<period>
s)
OK
Exec Command
AT^MONI
Response(s)
See: Section 8.9.1 , AT^MONI responses
OK
Write Command
AT^MONI= <period>
Response(s)
See: Section 8.9.1 , AT^MONI responses
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS - + + + + + + - - -
<period>
(num)