Altera Arria V Hard IP for PCI Express User Manual
Page 228
17–6
Chapter 17: Testbench and Design Example
Chaining DMA Design Examples
Arria V Hard IP for PCI Express
December 2013
Altera Corporation
User Guide
■
The chaining DMA design example connects to the Avalon-ST interface of the
Arria V Hard IP for PCI Express. The connections consist of the following
interfaces:
■
The Avalon-ST RX receives TLP header and data information from the Hard IP
block
■
The Avalon-ST TX transmits TLP header and data information to the Hard IP
block
■
The Avalon-ST MSI port requests MSI interrupts from the Hard IP block
■
The sideband signal bus carries static information such as configuration
information
■
The descriptor tables of the DMA read and the DMA write are located in the BFM
shared memory.
■
A RC CPU and associated PCI Express PHY link to the Endpoint design example,
using a Root Port and a north/south bridge.
The example Endpoint design Application Layer accomplishes the following
objectives:
■
Shows you how to interface to the Arria V Hard IP for PCI Express using the
Avalon-ST protocol.
■
Provides a chaining DMA channel that initiates memory read and write
transactions on the PCI Express link.
■
If the ECRC forwarding functionality is enabled, provides a CRC Compiler IP core
to check the ECRC dword from the Avalon-ST RX path and to generate the ECRC
for the Avalon-ST TX path.
■
If the PCI Express reconfiguration block functionality is enabled, provides a test
that increments the Vendor ID register to demonstrate this functionality.
The following modules are included in the design example and located in the
subdirectory <qsys_systemname>/testbench/<qsys_system_name>_tb
/simulation/submodules
:
■
<qsys_systemname> —This module is the top level of the example Endpoint design
that you use for simulation.
This module provides both PIPE and serial interfaces for the simulation
environment. This module has a
test_in
debug port. Refer to
which allow you to monitor and control internal states of the Hard IP.
For synthesis, the top level module is <qsys_systemname>’synthesis/submodules.
This module instantiates the top-level module and propagates only a small sub-set
of the test ports to the external I/Os. These test ports can be used in your design.
■
<variation name>.v or <variation name>.vhd— Because Altera provides five sample
parameterizations, you may have to edit one of the provided examples to create a
simulation that matches your requirements.