Grass Valley iControl V.6.02 - Manual (Page 223)

iControl
User Guide
213
The Densité Manager is an iControl service that allows you to manage multiple Densité
Communicators. If there are Densité frames on your network, you will automatically see the
Densité Manager service displayed in the iC Navigator window.
For the Densité Manager to be able to begin controlling services, you must specify the
IP address(es) of the Densité frame(s) that it will manage. For each frame specified in this way,
the Densité Manager opens a Densité Communicator.
To configure a Densité Communicator
1. On the iControl—Services management page, verify that at least one Densité Manager is
active (green).
In a network with multiple Densité frames, it may be necessary to run more than one
Densité Manager service, and to balance the load between them (Grass Valley recommends
a maximum of 150 streams per Densité Manager).
To add more Densité Managers, scroll to the bottom of the iControl Services Monitoring and
Configuration page.
Choose a number from the drop-down menu, and then click Apply.
2. Open iC Navigator (see page 566 ).
3. Click Logical view. Make sure that the Densité Manager service is visible, and that its status
is green.
4. Double-click the Densité Manager row.
REQUIREMENT
Before beginning this procedure, make sure you have opened the iControl—Services
management page (see
page 552 ).
Densité
Manager
service active