Grass Valley iControl V.6.02 User Manual
Page 258
Configuring Devices & Services
Rolling Back a Card’s Installed Package to the Pre-Upgrade Version
248
The selected log is displayed.
Rolling Back a Card’s Installed Package to the Pre-Upgrade Version
Perform this procedure if, after installing a package on a Densité card, you decide to restore
both the firmware and software of the card to their respective pre-installation versions.
To roll back a Densité card’s installed package to the pre-upgrade version
1. In Densité Upgrade Manager, in the row corresponding to the card whose installed
package you would like to roll back, select Rollback <version #> in the Available package
column.
Note: In the case where you are rolling back a package installation resulting from a
Force upgrade operation, the rollback operation effectively becomes a Force rollback
operation. That is, even though the firmware currently installed and the firmware you
are rolling back to bear the same version number, the rollback will proceed.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened Densité Upgrade Manager (see
• The Densité cards whose firmware and software you would like to downgrade are visible
in Densité Upgrade Manager.
• The package you would like to use to downgrade your Densité card has already been
uploaded to your Application Server (see