Grass Valley iControl V.6.02 - Manual (Page 412)

iControl and SNMP
Adding an OID Getter and Variable Getter from a MIB Module
402
Adding an OID Getter and Variable Getter from a MIB Module
Adding an OID Getter
To add an OID getter to the script
1. In SNMP Driver Creator, click the Script editor tab.
The Script editor appears in the main pane.
2. In the MIB Browser pane (left pane), right-click the MIB node, point to Add to script, and
then click Script OID getter.
See also
For more information about editing an existing alarm map any time after it has been
created, see
"Editing an Alarm Map, Trap Map, or Poller Profile" , on page 407.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened SNMP Driver Creator (see page 578 ).
• You have configured a name for your SNMP driver (see page 393 ).
• You have loaded a MIB module into SNMP Driver Creator (see page 390 ).
• [RECOMMENDED]: You are performing this procedure as a task within the context of an
approved workflow (see "[Workflow]: Creating an SNMP Driver" , on page 379).