Grass Valley iControl V.6.02 User Manual

Page 500

Advertising

Backup and Redundancy

Restoring an Offline, Configured Main Application Server to Online Status

490

Restoring an Offline, Configured Main Application Server to Online Status

This procedure assumes the following:

• A Main Application Server Autofailed to, or was manually taken over by, its Backup.

• All required maintenance and troubleshooting work on the configured Main Application

Server is complete.

• You would like the configured Main Application Server to be returned to online status as a

Main Application Server (with its original IP address and host name).

To restore an offline, configured Main Application Server to online status

1. In the Main area of the iControl—Redundancy configuration page, use the Configured IP

column to identify the Application Server that failed over or was manually taken over.

IMPORTANT: System behavior

Immediately following a Manual Takeover or an Auto-failover event, there is
no longer any redundancy as the configured Backup is currently in the active
role of a Main Application Server. In order to restore your system to full
redundancy, you must do one of the following:

• [Recommended option]: Fix any issues with the configured Main Application

Server that failed over or upon which you performed a Manual Takeover. Then

perform a Reverse Takeover to revert Application Servers to their configured

roles.

• Fix any issues with the configured Main. Then reconfigure this Application

Server in the role of Backup and the configured Backup in the role of Main.

• Replace the defective Application Server. Then perform a Replace Takeover to

revert the Backup Application Server to its Backup role and to use the

Application Server to take over the role of the defective Main Application Server.

REQUIREMENTS

Make sure you meet the following conditions before beginning this procedure:

• You have navigated to the iControl—Redundancy configuration page of the Backup