Grass Valley iControl V.6.02 - Manual (Page 266)

Access Control
Setting up Access Control
256
Here are the steps you would follow to set up Access Control in this scenario, along with
references to the associated procedures in this chapter:
To set up Access Control in the preceding example
1. Activate LDAP service — Open the iControl—Access control page (see page 556 ) of an
Application Server (e.g. Alpha) to set up and activate an LDAP service, including building a
list of managed domains and remote domain referrals (if any) (see
page 263 ).
2. Enable access control — Enable access control on Alpha (see page 269 ).
3. Configure users, roles, and permissions — Open iC Navigator from Alpha, and then use
the Privilege Management window to create users, assign roles (e.g. operator, admin), and
assign permissions (e.g. ability to open a control panel). Then open iC Creator and use the
Page Privilege Management window to assign Web-based permissions (e.g. ability to
open a Web site).
See:
• "Opening the Privilege Management Window in iC Navigator" on page 576
• "Opening the Privilege Management Window in iC Creator" on page 584