Grass Valley iControl V.6.02 - Manual (Page 67)

iControl
User Guide
57
If, however, you wish to have these services connect to GSMs running on Application Servers
on other subnets, you must explicitly specify the GSM locations. You do this by typing the
IP address of the target Application Server (on the remote subnet) in the iControl Lookup
locations page of the Application Server running the Densité, Imagestore, or other service on
the local subnet.
On the Application Servers in the different subnet, you need to specify the IP address of the
lookup service where a GSM is registered in the other subnet.
Adding an Alarm Publication Lookup Location
To add an Alarm publication lookup location
1. On the iControl—Lookup location page, under Alarm publication, type one of the
following:
• the IP address of an Application Server on a remote subnet that is running a GSM
• the IP address of an Application Server on a remote subnet that is running a lookup
service
2. Click Add lookup.
The address appears in the Alarm publication lookup table.
REQUIREMENT
Before beginning this procedure, make sure you have opened the iControl—Lookup location
page for the Application Server that is running the Densité, Imagestore, or other service you
wish to publish to remote GSMs (see
page 561 ).
Note: Use of the Name field to indicate the Application Server’s host name is
optional.