Acknowledging a channel alarm – Grass Valley iControl V.6.02 User Manual
Page 366
Alarms in iControl
Acknowledging Alarms on iC Web Pages
356
Acknowledging Alarms on iC Web Pages
To acknowledge an alarm on an iC Web page
• Right-click the alarm in the Web page panel, and then click Acknowledge.
The alarm’s acknowledged component turns green.
Acknowledging a Channel Alarm
To acknowledge a channel alarm
• Perform only one of the following steps:
•
Right-click on a thumbnail, and then click Acknowledge.
•
Right-click an individual alarm on the channel’s Web page, and then click
Acknowledge.
Once the channel alarm is acknowledged, the button changes from flashing red to solid red.
REQUIREMENT
Before beginning this procedure, make sure you have opened the appropriate iC Web page
(see
Note: The acknowledged component of alarms is not always visible on iC Web
pages. You can still determine if an alarm has been acknowledged by right-clicking—
if the
Acknowledge
command is grayed out, it means someone has already
acknowledged the alarm. In some cases, acknowledging an alarm on a Web page will
also stop it from flashing.
REQUIREMENT
Before beginning this procedure, make sure you have opened the appropriate iC Web page
(see
).