Grass Valley iControl V.6.02 User Manual
Page 501
iControl
User Guide
491
2. In the row corresponding to the Application Server you would like to restore to an Online
status, click Reverse in the Reverse Take-Over column.
The system performs a Reverse Takeover on the Application Server.
3. In your browser’s address bar, retype the configured IP address of the Application Server
you are restoring.
4. Navigate to the iControl—Redundancy configuration page (see
).
5. On the iControl—Redundancy configuration page, verify that the operation completed
successfully.
Note: The row for the Application Server that failed over (or was taken over) should
be yellow and the operational state should be Offline.
Note: Because this operation changes the physical hardware corresponding to the
Main’s IP address, the iControl—Redundancy configuration page is no longer able to
refresh.
Note: The Reverse Takeover operation can take several seconds before completing.