Rockwell Automation 20P PowerFlex Digital DC Drive - Manual (Page 28)

28 Rockwell Automation Publication 20P-UM001I-EN-P - February 2013
Chapter 1 Installation and Wiring
Removing the Drive Covers The appropriate protective cover(s) must be removed in order to access the drive’s
power and I/O terminals. The upper cover only needs to be removed to install an
optional communication adapter and service the drive. (See Installing a
Communication Adapter on page
337 for information.)
Frame A Drives
You must remove both the lower protective cover and the power terminal cover
on frame A drives to access the power terminals.
Remove the Power Terminal Cover
Remove the two screws as shown below and slide the cover down and off the
chassis.