Rockwell Automation 20P PowerFlex Digital DC Drive - Manual (Page 50)

50 Rockwell Automation Publication 20P-UM001I-EN-P - February 2013
Chapter 1 Installation and Wiring
Armature Converter Connections
Table 10 - Armature and Safety Ground (PE) Terminal Specifications
Figure 22 - Frame A Armature Converter Terminal Locations
Terminals Description
U, V, W Three phase AC input to the armature converter
C, D DC output to the motor armature
PE Safety ground
Fram
e
Drive Current Rating Code
(1)
Terminals Wire Size and Type Terminal Bolt
Size (mm) Tightening
Torque
N
•m (lb•in)
230V 460V 575 690
A 7P0…055 4P1…052 – – U, V, W, C, D, PE
See Cable and Wiring
Recommendations on
page 44
5 6 (53)
073…110 073…129 – – Terminal Block 12 (106)
B All All All – U, V, W, C, D 10 25 (221)
PE 8 15 (132.75)
C All All All All U, V, W, C, D 10 25 (221)
PE 8 15 (132.75)
D All All All All U, V, W, C, D, PE 12 45 (398.2)
(1) See Standard Drive Catalog Number Explanation on page 15 , positions 8, 9 and 10 for corresponding drive HP rating, armature amp rating and
field amp rating.
IMPORTANT Certain frame D drives require the use of a terminal adapter kit(s) for terminals
U, V, W, C and D. See Terminal Adapter Kits for Frame D Drives on page
250 for
details.
U C V D W PE
Front View
ATTENTION: Do not operate the drive with the power terminal cover removed.
Operating the drive with the power terminal cover removed may result in a
hazardous condition that could cause personal injury and/or equipment
damage.
Note: Front view of drive shown with bottom protective and power terminal covers removed. See Removing the
Drive Covers on page
28 for information on removing the drive covers.