Es and, Figure 44 – Rockwell Automation 20P PowerFlex Digital DC Drive User Manual
Page 67
Rockwell Automation Publication 20P-UM001I-EN-P - February 2013
67
Installation and Wiring
Chapter 1
Figure 43 - SA-SB Terminal Block Location on Frame B Drives
Figure 44 - SA-SB Terminal Block Location on Frame C Drives
Front of Drive
The SA-SB terminal
block is located at
the top of the drive.
Switching Power Supply board
SA-SB terminals
Back of control board EMI shield
The SA-SB terminal block is located on the Switching Power
Supply circuit board on the back of the control board EMI Shield.
1. Remove the top protective cover from the drive.
3. Loosen
captive
screws.
2. Disconnect cables XFCD and XR.
4. Lower control
board EMI shield
and disconnect
cable XSW from
Switching Power
Supply board (see
above).
XSW connector
To access the SA-SB terminal block:
3. Loosen captive
screws.