Rockwell Automation 20P PowerFlex Digital DC Drive - Manual (Page 340)

340 Rockwell Automation Publication 20P-UM001I-EN-P - February 2013
Appendix E Installing a Communication Adapter
Frames B and C
a. Loosen, but do not remove, the screws that secure the bottom cover to
the drive, then slide the cover down and off the drive chassis.
b. Loosen, but do not remove, the screws that secure the top cover to the
drive, then slide the cover up and off the drive chassis.
Disconnect DPI cable.
Frame B shown
=
IMPORTANT The HIM assembly is connected via a cable to the control board and
therefore will not pull free from the drive until disconnected. See step 4
on page
341 for instructions.
U V C D W
Frame B shown