HEIDENHAIN IK 5494-2D - Manual (Page 138)

116 QC5200 Series User’s Guide
Initial setup of the video probe system
The initial setup of the video probe system includes the addition of video magnifications with associated
zooms followed by the configuration of the highest magnification, configuration of the lower magnifica-
tions, calibration of camera skew and configuration of data collection parameters for each probe type. The
setup steps are diagrammed below and are explained in detail in the remainder of this chapter.
CAUTION
Probe setup functions are restricted to individuals who can provide the supervisor
password in one of the setup screens found under the Tools menu. Operators should
not attempt to perform any of the calibration or other procedures included in the
remainder of this chapter.
Adding magnifications with associated
zooms
The process of adding magnifications with associated zoom positions is dia-
grammed here and explained in subsequent paragraphs.
As the system is used, video magnifications are selected from the Probe
menu, and more often in typical use from the Probe toolbar.
As new magnifications are added, they automatically become available for
selection from the Probe menu. However, magnifications must be added to
the Probe toolbar using
the Tools/Custom-
ize/Toolbars screen to
become available from
the Probe toolbar.
Magnifications are selected from the Probe menu
or from the Probe toolbar
This page Page 120 Page 120 Page 131 Page 134