HEIDENHAIN IK 5494-2D - Manual (Page 5)

i
Introduction
This User Guide describes the operation of the video edge series of QC5200 metrology products. This series
of QC5200 instruments conducts a wide variety of precise 2-D measurements using a wide assortment of
video edge detection probes. The QC5200 software supports manual part positioning and feature measure-
ment under user control, and CNC part positioning and automated measurement under program control.
While it is likely that this Guide includes some material that doesn’t apply to your specific QC5200 system,
information pertaining to your system will be easy to find using the Table of Contents and Index.
Who should read this Guide?
This Guide is necessary for the efficient operation of the QC5200 system. Operators and supervisors will
find the contents invaluable in conducting measurements, programming automatic functions and reporting
results. User setup functions are also described that will help users and supervisors customize the QC5200
measurement tools, user interface screens and report formats.
Prerequisites
Operators and supervisors are assumed to have a good basic understanding of dimensional metrology
theory and practice, and a good understanding of Microsoft Windows use and conventions.
Conventions used throughout this Guide
The conventions used to call attention to notes, cautions and warnings, and the shorthand used to show
menu navigation paths are described below:
Notes, warnings and cautions
This guide uses the following icons to highlight note, warning and caution information:
NOTE
The note icon indicates additional or supplementary information about an activity or
concept. Notes are shown in bold type.