HEIDENHAIN IK 5494-2D - Manual (Page 361)

339
1
0
Supervisor Setup
Opening the last part automatically
The QC5200 can be configured to automatically open the last active
part file upon startup. Check the Open last part... box to open the last
part file.
Tracking user activity
User activities such as key presses and mouse clicks can be logged to facilitate troubleshooting and other
diagnostic processes. The logged file is stored in the Recent Activity
folder at the root of the QC5000 directory. Click the Enable track-
ing... box to log user activities.
Click Help, Diagnostics, and then Show this session’s ac-
tivity to display the logged file.
NOTE
Enabling this logging feature uses small
amounts of system memory and proces-
sor time. However, older systems might
run a little slower when the logging fea-
ture is enabled.
Enable simple zeroing of the DRO axis positions
By default, when a DRO axis button is clicked, a zero position must be measured for the associated axis.
Check the Enable simple zeroing... box to zero an axis immediately at its current position without measure-
ment.
General Parameters