HEIDENHAIN IK 5494-2D - Manual (Page 321)

299
1
0
Supervisor Setup
Chapter 10:
Supervisor Setup
Setup screens are often made available to the supervisor by the OEM or Metronics distributor for custom-
izing display and some measurement parameters. The specific screens that are available are determined for
each system by the OEM or distributor responsible for system setup and maintenance. A collection of setup
screens typically made available to supervisors is included in this chapter. Some of these screens can also
be made available to the end-users by the supervisor. The setup screens omitted from this chapter are not
intended for supervisors or end-users. Setup screens presented in this chapter are listed below:
Tools/Customize menu item screens
Including a startup message ......................................................................300
Customizing colors ...................................................................................301
Specifying on-screen help tips ..................................................................305
Specifying error messages ........................................................................306
Specifying status bar information .............................................................308
Customizing toolbars ................................................................................309
Tools/Options menu item screens
Setting up programming parameters .........................................................314
Specifying the maximum program executions ..........................................317
Restricting access to setup screens ............................................................318
Configuring measurement parameters ......................................................320
Displaying parts and probe position ..........................................................322
Configuring joystick and footswitch buttons ............................................327
Setting the display of resolution, time and date ........................................330
Specifying encoder parameters .................................................................331
Specifying file names, locations and backups ..........................................332
Setting serial port, machine zero and general parameters .........................337
Setting up the video probes .......................................................................340
Tools/CNC menu item screens
Setting up the joystick ............................................................................... joystick joystick 350