Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1044)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1028 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
5.6.4.11 MEAS TC Cond
5.6.4.11.1 MEAS TC Cond - Overview
Dialog window: Method ▶ MEAS TC Cond ▶ Properties... ▶ MEAS TC Cond - 'Com-
mand name'
Command for the Measurement of the temperature coefficients of
the conductivity.
Instruments
This command can be executed with the following devices:
Conductometer: 712, 856
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS TC Cond are configured on the
following two tabs:
￭ General/Hardware
Parameters for devices, sensors and stirrers.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Additional measured values
Defining further measured values which can be saved as additional col-
umns in the measuring point list.
Command variables
The following command variables are generated in the method run by the
command MEAS Cond and can be used in formulas under the designa-
tion 'Command name.Variable designation':
Designation Description
.BP{x}.MEA Measured value for the break point (1…9) in the unit
of the measured value
.BP{x}.TEM Temperature for the break point × (1…9) in °C
.BP{x}.TIM Time for the break point × (1…9) in s
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started