Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 414)

4.8 Subwindow Curves ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
398 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Selection 13 colors | light green
Default value light green
Auxiliary lines
Selection of a color for the auxiliary lines.
Selection 13 colors | blue
Default value blue
4.8.4.6 Curve properties - Measuring point list
Tab: Database ▶ Curves ▶ Properties curves # ▶ Measuring point list
Parameters for the display of the measuring point list.
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved
per curve window and per client.
Selection DET | MET | SET | MEAS | MEAS T/Flow | MEAS
TC Cond | MEAS Ref | MEAS TMF | MEAS Spec
| MEAS Opt | CAL Spec | KFT | KFC | BRC | STAT
| DOS | TET
Default value DET
Note
When the dialog window is opened, those Command type will be
selected per default which applies for the curve shown in the curve
window.
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be
scaled automatically. In this case the fields Start value and End value
cannot be edited.
Available columns
Display of all fields that can be displayed as columns in the measuring
point list. The display depends on the command type.
Displayed columns
Display of all fields that will be displayed as columns in the measuring
point list.