Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1262)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1246 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Solution name
Name of the solution for which the result is to be saved as titer.
Selection List of all the solutions defined
Note
If no solutions have been defined, then the selection box will be empty.
The creation of solutions is described in the configuration (see Chapter
6.6.1, page 1392).
Save result as global variable
on | off (Default value: off)
The result will be saved under the selected name as global variable if this
option is activated (see Chapter 6.10, page 1461). In all cases, only the
single value for this result will be saved as a global variable, even if the sta-
tistics are enabled for this result.
Global variable
The result is saved as new value for this global variable.
Selection List of all the global variables defined
Note
If no global variables have been defined, then the selection box will be
empty. The creation of global variables is described in the configuration
(see Chapter 6.10, page 1461).
Note
For global variables which are newly calculated during a determination
in a CALC command and which are saved in the configuration, the cur-
rent values are available for additional calculations in the same determi-
nations from this instant. This is not the case for determinations running
at the same time on other workplaces; here, the values available at the
start of the determination are applied.
[Save as template]
Open the dialog window Save result template in order to save the
result parameters as template for the creation of new results (see Chapter
5.6.8.2.6.2, page 1247).