Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1628)

7.20 IO controller ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1612 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Range 0 ... 214783647
Default value 0
Invert signal
on | off (Default value: off)
If this checkbox is activated the received input signal will be inverted.
Message
Only active and editable for the Port type = Level detector.
Message by E-mail
on | off (Default value: off)
The message is additionally sent to the e-mail address defined under [E-
mail] if this option is activated. The message is sent in text format.
[E-mail]
[E-Mail] opens the Send E-mail window (see Chapter 2.6.1, page 95).
Acoustic signal
on | off (Default value: off)
If this option is activated, an acoustic signal will be emitted additionally to
the message defined above
Whichever Action has been selected, the corresponding message is also
displayed on the Messages tab of the Live display (see Chapter 3.8.4,
page 183).
If, because of an Action, the message is documented in the determina-
tion, it is displayed in the determination overview on the tab Messages in
the subwindow Information (see Chapter 4.6.6, page 365) and can be
put out in a report.
Action
Only active and editable for the Port type = Level detector.
If the fill level is too low and the level detector is therefore active, one of
the following actions will automatically be carried out at the start test:
Selection Document message | Display message | Cancel
determination
Default value Display message
Document message
The message that the level detector on the device is active will auto-
matically be saved in the determination.