Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1669)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Instruments
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1653
Visible only in cases of stepping motors where Type = Linear drive.
Range -214783647 ... 214783647 mm
Default value 0 mm
Angle
The angle to be moved to.
Not visible in cases of stepping motors where Type = Rotary drive.
Range -214783647 ... 214783647 °
Default value 0 °
Ports assigned
The port information for these ports is automatically read out of the step-
ping motor controller.
Reference position
Display of the port description.
Safety switch 1
Display of the port description.
Safety switch 2
Display of the port description.
Safety switch 3
Display of the port description.
Brake
Display of the port description.
Note
The ports assigned and the further properties of the stepping motor
(e.g. speed, acceleration, axis feed, ...) are defined in the program IO
ControlCenter.
7.21.7 Properties - GLP
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ GLP
GLP test date
Date of the last GLP test. This date can be selected by clicking on in
the dialog window Select date (see Chapter 2.5.1, page 92).