Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1436)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1420 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
￭ Limit values
Definition of limits monitoring for slope and electrode zero point.
￭ History
Display of the last 10 calibration values.
￭ Electrode test
Information about the electrode test.
6.7.3.2 Properties - Sensor
Tab: Configuration ▶ Sensors ▶ Edit ▶ Properties ▶ Sensor
Sensor name
Name of the sensor.
Input 24 characters
Note
The sensor name for the 5 non-deletable default sensors pH elec-
trode, Metal electrode, ISE electrode, Temperature sensor and
Conductivity sensor cannot be changed.
Sensor type
Display of the type of sensor. Intelligent sensors are marked in addition
with IS.
Ion
Display of the ion to be measured and its valence. This parameter only
appears for ISE electrodes.
Order number
Order number of the sensor (read-only for intelligent sensors and the
Thermoprobe).
Input 24 characters
Default value 'empty'
Sensor serial number
Serial number of the sensor (read-only for intelligent sensors and the Ther-
moprobe).
Input 10 characters
Default value 'empty'
Device
For non-intelligent sensors it is possible to select the device to which the
sensor is connected. All the devices in the device table which have a