Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 65)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 49
Designation Description Commands
.MA.TEM Temperature for the maximum
measured value in °C DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)
.MA.TIM Time in s until the maximum
measured value is reached DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)
.MA.TRN Transmission for maximum meas-
ured value in % MEAS Opt
.MA.VOL Volume with maximum measured
value in mL DET, MET, SET,
KFT, STAT
.MI.CNT Intensity for minimum measured
value in counts MEAS Opt
.MI.MEA Minimum measured value in the
unit of the measured value DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)
.MI.TEM Temperature with minimum
measured value in °C DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)
.MI.TIM Time for the minimum measured
value in s DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)
.MI.TRN Transmission for minimum meas-
ured value in % MEAS Opt
.MI.VOL Volume for minimum measured
value in mL DET, MET, SET,
KFT, STAT
.MN.MEA Average of the measured value in
the unit of the measured value MEAS T/Flow
.MR.MRC Correlation coefficient for mean
dosing rate for the whole range STAT, DOS