Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 716)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
700 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Designation Description
.NMP Number of measuring points in measuring point list
.SLO Electrode slope of the sensor used for the command (in
%)
.SME Start measured value (measured value after processing
the start conditions) in the unit of the measured value
.STE Start temperature (temperature after processing of the
start conditions) in °C
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
.SVA Start volume absolute (volume that was added accord-
ing to the start condition "start volume") in mL
.SVT Total start volume (volume that was added in depend-
ence on all three start conditions) in mL
.TITER Titer value of the solution used for the command
5.6.3.4.3.2 SET pH - General/Hardware
Tab: Method ▶ SET pH ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the control device, the dosing device, the sen-
sor and the stirrer are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.