Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1091)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1075
Identifi-
cation Description
.EME Final measured value (measured value after processing of
the command) in the unit of the measured value
.ENP Electrode zero point calculated from the calibration
.ETE End temperature (temperature following processing of
the command) in °C
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
.IME Initial measured value (measured value before start condi-
tions are processed) in the unit of the measured value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.MTE Temperature measurement with sensor; 1 = on, 0 = off)
.RES Calculated result of the standard addition in the selected
unit
.SLO Electrode slope calculated from the calibration
.STY Type of stop with which the command was stopped: 1 =
normal;0 = manual or after error
.TITER Titer value of the solution used for the command
.VAR Variance of the calculated result of the standard addition
in the selected unit
.VOL Dosed volume
5.6.4.18.2 STDADD dos - General/Hardware
Tab: Method ▶ STDADD ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the control device, the dosing device, the sen-
sor and the stirrer are defined on this tab.