Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1258)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1242 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Selection empty | ppm | % | g/L | mg/L | mg/mL | mg/100
g | mol/L | mmol/L | mL | µL | g | mg | µg | °C | s |
mV | µA | S/cm | mS/cm | µS/cm | µL/min
Default value empty
Decimal places
Number of decimal places for the output of the calculated result. This
parameter is ignored for results of the type text or date/time.
Range 0 ... 5
Default value 2
Assignment
Assigns the result to one of the 25 possible result columns RS01 ... RS25
in the determination overview in which the result is entered.
Selection RS01 … RS25 | first unallocated result varia-
ble | none
Default value first unallocated result variable
none
The result will be assigned to no result column and displayed only in
the subwindow Results .
Note
The assignments RS01 … RS25 can be used repeatedly in various
CALC commands. If this is the case, then only the last result calculated
will be entered in the assigned result column. By doing this it is possible
either to display alternative results calculated in different CALC com-
mands in the same result column or to use the same report template.
Caution
If the same Assignment is reused in several CALC commands with dif-
ferent Result names, then only the most recently calculated result will
be saved in the determination. All other results are either no longer
available or invalid if used in other formulas!
Statistics
on | off (Default value: on)
Mean value, absolute and relative standard deviations are calculated for
the result if this option is enabled. Statistical calculations are only carried
out if statistics is also activated in the START command and in the Run
window.