Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1469)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1453
Note
For common variables which are newly calculated during a determina-
tion in a CALC command and which are saved in the configuration, the
current values are available for additional calculations in the same
determinations from this instant. This is not the case for determinations
running at the same time on other workplaces; here, the values availa-
ble at the start of the determination are applied.
6.9.2 Table of common variables
6.9.2.1 Table of common variables
Subwindow: Configuration ▶ Common variables
Contents
The table of common variables shows the following information about the
common variables as standard:
Name
Name of common variable.
Type
Type of common variables (Number, Text or Date/Time).
Value
Value of common variables.
Unit
Unit of the common variables.
Assignment date
Date of the last value assignment for the common variable.
Assignment method
Name of the method used to assign the value.
User
Short name of the user logged in during value assignment.
Next assignment
Date on which the next value assignment is to be carried out. If monitor-
ing the common variable is switched on and the set date is before the cur-
rent date (i.e. the value assignment has not yet been carried out) then the
date will be shown in red.