Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 20)

1.4 Method editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
1.4 Method editor
Introduction
The new graphic method editor gets more out of your titration system.
With the aid of the numerous templates, methods can be created fast and
easily. For most routine and automated tasks, there are tried and tested
methods available. Just a few clicks and they are adapted and ready to
use.
One new feature is that actions running parallel in terms of time can
now be programmed and linked. Together with the new Titrando System
and the Robotic Sample Processors, a sample can be prepared while the
previous one is being titrated. This saves time and increases the sample
throughput. The crowning feature is the simultaneous processing of sev-
eral samples at once. This means that one Titrando can carry out two
titrations at the same time. As a result, sample throughput is doubled!
tiamo is flexible and accommodates itself to analysis procedures, and not
the other way around.
Overview of functions
￭ Graphical method editor (see Chapter 5.6.1.2, page 440)
￭ Method manager (see Chapter 5.3.1, page 419)
￭ Separate management of access permissions for each method group
(see Chapter 5.4.2.3, page 431)
￭ Templates for method development and calculation (see Chapter
5.2.1, page 406)
￭ Plausibility check for methods (see Chapter 5.2.5, page 415)
￭ Comments can be added to the methods (see Chapter 5.2.4.2.9, page
414)
￭ Parallel runs (see Chapter 5.6.10.3.1, page 1279)
￭ Loop functions (see Chapter 5.6.10.4.1, page 1281)