Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 574)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
558 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
descending
Only equivalence points with a negative slope of the titration curve will
be recognized.
off
Equivalence point recognition is switched off.
Evaluation with measured value window (Upol)
EP criterion
Criterion for the recognition of equivalence points which is valid for all
windows. Equivalence points whose ERC is smaller than the set EP crite-
rion will not be recognized.
Titrino
Range
0 ... 200
Default value 5
[New]
Open the dialog window Measured value window # in which the
parameters for a new window can be entered (see Chapter 5.6.3.2.5.9,
page 564).
[Properties]
Open the dialog window Measured value window # in which the
parameters for the selected window can be edited (see Chapter
5.6.3.2.5.9, page 564).
[Delete]
Delete the window selected in the table.
Evaluation with volume window (mL)
[New]
Open the dialog window Volume window # in which the parameters
for a new window can be entered (see Chapter 5.6.3.2.5.10, page
565).
[Properties]
Open the dialog window Volume window # in which the parameters
for the selected window can be edited (see Chapter 5.6.3.2.5.10, page
565).
[Delete]
Delete the window selected in the table.