Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 35)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 1 Introduction
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 19
￭ The description of Fill automatically at end was not correct in the
online help for the ADD command.
￭ If a new stepper motor was created in the command STEPPING
MOTOR on the tab Stepping motors or the properties of an existing
one viewed, then the title of the dialog window was Method varia-
ble - (instead of STEPPING MOTOR #, e.g. similar to the command
DIGITAL OUT).
Program part Configuration
￭ If a barcode reader and a balance were included first in the device con-
figuration for the light version, then it was no longer possible to
include Metrohm devices.
￭ The incorrect text designation for the colorimetric sensors was used
(Sensor instead of Colorimetric sensor) in the user management
under "Access rights for Group 'Group designation', Configuration,
Functions".
￭ The online help for the dialog window Limit values for colorimetric
sensor – 'Name of the colorimetric sensor' was not available.
￭ After a pH calibration, the calibration date is also entered on the tab
Calibration data with the sensors, among other things. If, after a suc-
cessful calibration, the intelligent sensor as deleted from the configura-
tion and then included again, then the Date ELT could be seen in the
field Calibration date.
￭ In the online help for Export configuration data and Import con-
figuration data, the descriptions for Export templates and Elec-
trode type templates were not available.
￭ If one cannot log in within the number of attempts specified in the
security settings and if at the same time the option Message by e-
mail is active, then an E-mail will be sent to the specified address. Cli-
ent name was output as text in the subject line of this E-mail, for
which the associated value corresponded to the name of the com-
puter; Client name was replaced by Computer name.
Program part Manual control
￭ If the measurement of a spectrum with the Avantes spectrometer was
aborted by pressing [Stop], then the Stop button would switch cor-
rectly to [Start], but the spectrum would continue to be recorded.