Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1054)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1038 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Designation Description
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
.PK{#}.ABS Absorbance of the peak with the greatest absorbance
(maximum absorbance) for evaluation # (1…9)
.PK{#}.TRN Transmission of the peak with the greatest absorbance
(minimum transmission) for evaluation # (1…9) in %
.PK{#}.CNT Intensity of the peak with the greatest absorbance
(maximum intensity) for evaluation # (1…9)
.PK{#}.CNR Intensity in reference spectrum 'Command
name'.PK{#}.WVL for evaluation # (1…9)
.PK{#}.CND Intensity in dark spectrum 'Command
name'.PK{#}.WVL for evaluation # (1…9)
.PK{#}.WVL Wavelength of the peak with the greatest absorbance
for evaluation # (1...9) of the discovered maximum
.PK{#}.SAT Specification as to whether the detector was saturated
with 'Command name'.PK{#}.WVL for evaluation #
(1…9)
5.6.4.13.2 MEAS Spec - General/Hardware
Tab: Method ▶ MEAS Spec ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.