Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1615)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Instruments
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1599
Timeout
Maximum waiting time for receiving characters. If this time is exceeded,
receiving will be stopped.
Range 1000 ... 9999 ms
Default value 2000 ms
Terminator for send
Terminator for send in hexadecimal code.
Selection \0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value \0D\0A
(\0D = CR, \0A = LF)
Terminator for receiving
Final character for receiving in hexadecimal code.
Selection \0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value \0D\0A
(\0D = CR, \0A = LF)
Code page
Code page used for the data transfer.
Selection Cp437 | Cp850 | Cp852 | ASCII
Default value Cp437
[Connect]
Establishes the connection to the balance. The dialog window Establish
connection appears (see Chapter 7.18.5, page 1601).
[Disconnect]
Disconnects the connection to the balance (only then the device can be
deleted out of the configuration).
7.18.4 Properties - GLP
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ GLP
GLP test date
Date of the last GLP test. This date can be selected by clicking on in
the dialog window Select date (see Chapter 2.5.1, page 92).
Comment on GLP test
Comment on GLP test.
Input 1000 characters