Festo Контроллер позиционирования CPX-CMAX - Manual (Page 163)

4. Faults and diagnostics
4−27
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Fault group 6 ć error in valve
CPX error group 106 (CPX−MMI: [Error in valve] ) continued
No. Message Cause/description Error handling Type 1)
65 Operating voltage of the
valve outside of the tolĆ
erance range (under−
voltage) The valve reports inĆ
sufficient operating voltĆ
age. Either the cable
between the CMAX and
the valve is faulty or the
valve. · Check the cables at
the axis string.
· Check the valve, exĆ
change if necessary.
Level: F2
Reset: F
Info: x
66 Overload at digital valve
output The valve reports an
overload on the digital
output. · Check and correct the
circuitry. Level: F2
Reset: F
Info: x
67 Overload at 24V supply
output of valve The valve reports an
overload on the voltage
output. · Check and correct the
circuitry. Level: F2
Reset: F
Info: x
68 Preliminary warning
valve over−temperature The valve reports a high
operating temperature.
(Ambient temperature
too high). · Provide sufficient
cooling. Level: W
Reset: F
Info: x
1) Level: fault level, see section 4.2.3; (can alternatively be parametrised as a warning or error)
Reset: behaviour upon reset, see section 4.2.4
Info:
ć = no info; x = additional info, see FCT or section 4.3.3