Festo Контроллер позиционирования CPX-CMAX - Manual (Page 331)

A. Notes on commissioning and service
A−23
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Defined error codes
Message Effect
E01 More than one component (cylinder and
valve) were replaced for another.
Identification must be reset and executed
anew once the setpoint configuration has
been adjusted
Cylinder (type, length, diameter) does not
correspond to the setpoint configuration.
been adjusted.
Or reset to previous status, as required.
Measuring system (type, length) does not
correspond to the setpoint configuration.
Valve (type) does not correspond to the setĆ
point configuration.
W08 A component (cylinder, sensor or valve) was
replaced for another.
Identification should be repeated, but operĆ
ation is still possible.