Festo Контроллер позиционирования CPX-CMAX - Manual (Page 328)

A. Notes on commissioning and service
A−20
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Modifications outside of the specified tolerances are not perĆ
missible. To prevent an excessive extent of modifications
through repeat downloads, a copy of the data is created at
the time of serial number transfer and this is used as a basis
for comparison (PNU 1195).
After identification, modification of other parameters is reĆ
stricted.
Parameters Permissible deviations for nominal/actual comparison
Prior to transfer of SN After transfer of SN After identification
Application data
Supply pressure any changes any changes 1 bar
Mounting position any changes any changes 3 °
Settings
WP mass at power−on 1) any changes any changes any changes
Dual axis any changes any changes no deviation
Clamping unit any changes any changes any changes
Through piston rod any changes any changes no deviation
1) Workpiece mass(mass moment of inertia when switching on
Tab. A/3: Permissible deviations for nominal/actual comparison