Festo Контроллер позиционирования CPX-CMAX - Manual (Page 405)

C. Configuration with CPX node
C−7
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Note
CPX terminals with the CMAX
always require new parameĆ
trisation and commissioning after exchanging the CPX terĆ
minal or the CMAX, since the parameters and the data asĆ
certained during commissioning are only stored in the
CMAX, see section 1.1.2.
The CMAX cannot be parametrised via the start−up parameĆ
trisation. This must always be done via the FCT or via the
special parametrisation function.
Fig. C/3: No specific parameters